This is an old revision of the document!
Table of Contents
Confetti102 Chua's Diode
That's a Chua's Diode board for the analog computer Confetti.
With the jumper set one can connect the output to the common ground, if no jumper is used one can use the output connector instead.
In combination with the Confetti101 Gyrator one can build a Chua's Oscillator.
Analog Computing 01 - Chua's Circuit
Paper PCB
Parts
- Resistors:
- 2x 330 Ohm
- 2x 3.3 kOhm
- 2x 47 kOhm
- Diodes:
- 2x 1N4148
- Semiconductors
- 1x TL072 OpAmp
- Mechanical:
- 1x IC socket, 8pins
- 1x 2 pin strip
- 3x 2 pin header, female
- 2x pin header, female 90° 1×3, 1×2
- 2x pin header, male 90° 1×3, 1×2
- 1x jumpers
- Trimpotentiometer:
- 1x 5 kOhm
License
The Confetti102 Chua Diode was designed by Wolfgang Spahn 2015-20.
It is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
